Professional Documents
Culture Documents
ISSN No:-2456-2165
Abstract:- These days, due to the increase in powder are used as alternative materials to fine aggregate
construction, there is a lack or shortage in the supply of [4].
natural sand. Due to large demand and low supply, the
cost factor gets increased, just as we depreciate the II. CERAMIC TILE WASTE
natural sand sources.
Clay is used in the manufacturing of ceramic tiles.
We are using ceramics in construction in various Durability hardness and high resistance to heat, and
forms, like tiles, sanitary work, etc. After demolition, this chemicals are some properties of ceramic waste tiles. The
ceramic tile waste is the biggest challenge to decompose. use of ceramic tiles waste in concrete formation resolves
By using this ceramic tile waste is a partial replacement some disposable problems and affects the properties of fresh
with crushedsand, which is an alternative to natural sand and hardened concrete they can use as a replacement [4].
and is currently used in practice.
Ceramic waste is obtained from Industrial waste and
Keywords:- Waste Ceramic Tile ,Crushed Sand, residential waste which cannot be reprocessed having a
Compressive Strength. thickness range from 5 mm to 15 mm stone grinding
machine milled ceramics of 5 mm for fine aggregate and 10
I. INTRODUCTION mm for coarse aggregate and can replace natural sand [5].
As per test results Crushed sand with conventional Ceramic Waste aggregate is obtained mainly from the
concrete, can be used as fine aggregate in concrete ceramic floor, wall tiles, ota, Lagos, etc which is having a
production. As per test results Crushed sand can be used as water absorption percentage of 0.55% the ceramic pieces
replacement shows similar results for compressor strength were crushed and sieved through corresponding types of
modulus of fracture and lower degree of shrinkage [1]. equipment and we obtained angular-shaped granules [6].
Construction and Demolition are based on having a Ceramic waste is divided into two types according to
large proportion in the environment which is hazardous to Torgal and Jalali (2018) red paste contains products like
human health, so it becomes necessary to manufacture C & brick, block, and roof tile. while white paste contains wall
D concrete. To save natural sand resources partial or full tiles, floor tiles, sanitary ware, etc. while white paste uses
replacement of natural sand must be done with M sand, more in practice due to its higher volume [7].
Query sand dust, and ceramic waste. Natural sand gets
replaced by ceramic aggregates [2]. A. Effect of Ceramic Waste On Workability Of Concrete
Slump value is inversely proportional to ceramic waste
The construction industry demands more use of natural content in concrete. whichmeans ceramic waste content has a
resources which results in a threat to the environment.To higher water absorption value. the cohesiveness of the
overcome these issues some parallel ways are needed to find concrete is affected by the inclusion of ceramic waste [8].
an alternative. Removal of waste is the biggest problem in the
front right now, which contains construction and demolition The water-cement ratio is inversely proportional to the
waste up to 75% of total waste production. Construction and workability of fresh Concrete. Also, the amount of tile is
Demolition waste contains around 54% of ceramic waste inversely proportional to the slump value of concrete. The
partial replacement of ceramic tile waste affects the data is based on two major components the mixing water-
properties of fresh and hardened concrete which can solve cement ratio and waste ceramic tile content [3].
the problem and make concrete economical [3].
B. Effect of ceramic waste on concrete density
The combination of cement, coarse aggregate, fine The Measurement of concrete solidity is known as the
aggregate, and water known as concrete has been widely density of concrete. Observation found that concrete density
used in construction due to its durability. Fine aggregate and gradually increases with curing. Ceramic waste lighter than
coarse aggregate are natural and cement is manufactured.As normal course aggregate results in a lower density of
the population increased the demand for natural sand i.e. concrete. self-weight of concrete decrease due to the addition
fine aggregate also increased and the deflection of natural of ceramic waste [8].
resources started.waste ceramic tile and periwinkle shell