Heater or furnace troubleshooting tips for Jacksonville, FL residents!
Any sudden unexpected malfunction or breakdown of the unit may leave the homeowner stressed. It is always recommended to get highly experienced heating installation Jacksonville, FL, to avoid future breakdowns or repairs. Troubleshooting tips for heating repairs in Jacksonville, FL! Instead of stressing out about the heating repair Jacksonville, FL, one can follow the given troubleshooting tips before calling a technician.
1. Check the thermostat at first. Ensure the thermostat being set in a heat position. There are even many chances for the switch to be turned of accidentally. Ensure the setting being high for the furnace to provide heat air all over the place. If it does not help, call a professional heating repair Jacksonville, FL. 2. Check the air filter being free of clog. Any dirty air filter is clogged with dust or dirt will find it difficult to provide the normal performance of the unit. It could even damage the unit completely and can even shut down or breakdown. Replacing or cleaning the air filter with a new one might solve the issue. Jacksonville, FL heating services technicians ofer instant solutions for such repairs. 3. If the thermostat is completely blank or doesn’t show any light, then it might be a sign that the batteries are low. Replace the batteries of the thermostat regularly, which might be the reason for the breakdown. 4. The furnace should have enough power supply to run efficiently even with the proper functioning thermostat set at on or heat position. If you didn’t hear the startup noise usually heard, then check the power being plugged in and turned on. 5. Check the circuit breaker and look for the switch labelled furnace being turned on or not. If there is no label, then check for the switch that is in the opposite direction than the others. Change the position and notice if any changes happen. 6. Check the switch of the furnace. Look for the silver box with a white switch situated at the side of the furnace. Check if the switch is pushed
down. If it is in the down position, change to one position and wait for few minutes for the furnace to start. 7. An error code is flashed if anything goes wrong in the unit for the system manufactured after 1990. Each code in the panels has its meaning which has a key inside the furnace with access panels. 8. If the furnace at your home uses a pilot light, then check the manual provided by the unit and try relighting the unit safely. 9. The gas valve in the unit is usually untouched. The flow of gas is turned on only when the valve is in a vertical position. Weather Engineers- Popular for heating installation Jacksonville, FL! Even with all the troubleshooting steps, even the furnace didn’t start, then contact Weather Engineers for the best service.